17-29
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D37 Reset a TCC2/TCC2P Card Using CTC
DLP-D37 Reset a TCC2/TCC2P Card Using CTC
Warning
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard.
Statement 206
Note When CTC is used to reset a TCC2/TCC2P card, the system ensures that the database is protected from
harm.
Note When a software reset is performed on an active TCC2/TCC2P, the AIC-I card goes through an
initialization process and also resets. The AIC-I card reset is normal and happens each time an active
TCC2/TCC2P card goes through a software-initiated reset.
Step 1 In node view, right-click the TCC2/TCC2P card to reveal a shortcut menu.
Step 2 Click Reset Card.
Step 3 Click Ye s when the confirmation dialog box appears.
Step 4 Click OK when the “Lost connection to node, changing to Network View” message appears.
Note For LED behavior during a TCC2/TCC2P reboot, see Table 19-4 on page 19-55.
Step 5 Confirm that the TCC2/TCC2P card LED is amber (standby).
Step 6 Return to your originating procedure (NTP)
Purpose This procedure resets the TCC2/TCC2P card and switches the node to
the redundant TCC2/TCC2P.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
