6-103
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D325 Create an STM Test Circuit around the Ring
• Fully Protected—Routes the circuit on a protected path.
• Unprotected—Creates an unprotected circuit.
• PCA—Routes the member on a MS-SPRing protection channel.
Step 12 To set preferences for all members, choose the member protection type:
• Fully Protected—Routes the circuit on a protected path.
• Unprotected—Creates an unprotected circuit.
• PCA—Routes the member on a MS-SPRing protection channel.
Step 13 Click Next. If you chose Fully Protected or PCA, click OK to continue. If not, continue with the next
step.
Step 14 In the Route Review and Edit area, node icons appear so you can route the circuit manually.
Step 15 Complete the “DLP-D26 Provision a VCAT Circuit Route” task on page 17-20.
Step 16 Click Finish.
Note Depending on the complexity of the network and number of members, the VCAT circuit creation
process might take several minutes.
Step 17 When all the circuits are created, the Circuits window appears. Verify that the circuit you created appears
in the window.
Step 18 Complete the “NTP-D62 Test High-Order Circuits” procedure on page 6-66.
Stop. You have completed this procedure.
NTP-D325 Create an STM Test Circuit around the Ring
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at an ONS 15454 SDH on the network
where you will create the circuit. If you are already logged in, continue with Step 2.
Step 2 If you want to assign a name to the circuit source and destination ports before you create the circuit,
complete the “DLP-D314 Assign a Name to a Port” task on page 20-7. If you want CTC to assign a name
automatically based on circuit type, node name, and sequence number, continue with Step 3.
Step 3 From the View menu, choose Go to Network View.
Step 4 In the Circuit Creation dialog box, complete the following fields:
• Circuit Type—Choose VC_HO_PATH_CIRCUIT.
Purpose This procedure creates an STM test circuit that routes traffic around a ring
with the source and destination located on different ports of the same node.
Tools/Equipment None
Prerequisite Procedures NTP-D127 Verify Network Turn-Up, page 6-5
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
