15-26
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 15 Maintain the Node
NTP- D346 Import Network Element Defaults
Note Changes to most node defaults reprovision the node when you click Apply. Changes made to
card settings using the Defaults Editor do not change the settings for cards that are already
installed or slots that are preprovisioned for cards, but rather, change only cards that are installed
or preprovisioned thereafter. To change settings for installed cards or preprovisioned slots, see
Chapter 10, “Change Card Settings.”
Note Changing some NE defaults can cause CTC disconnection or a reboot of the node in order for
the default to take effect. Before you change a default, view the Side Effects column of the
Defaults editor (right-click a column header and select Show Column > Side Effects) and be
prepared for the occurrence of any side effects listed for that default.
Step 7 If you are modifying node-level defaults, a dialog box appears confirming whether you want to apply
defaults for node level attributes that will override current provisioning. Click Yes .
Step 8 If you are modifying the IIOP Listener Port setting, a dialog box appears warning you that the node will
reboot and asks if you want to continue. Click Ye s .
Stop. You have completed this procedure.
NTP-D346 Import Network Element Defaults
Note For a list of card and node default settings, refer to the “Network Element Defaults” appendix in the
Cisco ONS 15454 SDH Reference Manual.
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to import NE
defaults.
Step 2 Click the Provisioning > Defaults tabs.
Step 3 Click Import.
Step 4 If the correct file name and location of the desired file do not appear in the Import Defaults from File
dialog box, click Browse and browse to the file you are importing.
Step 5 When the correct file name and location appear in the dialog box, click OK. (The correct file name is
15454SDH-defaults.txt if you are importing the factory defaults.)
Purpose This procedure imports the NE defaults using the NE Defaults editor. The
defaults can either be imported from the CTC software CD (factory
defaults) or from a customized file exported and saved from a node.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
