18-50
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D159 Delete a User on a Single Node
Step 6 Return to your originating procedure (NTP).
DLP-D159 Delete a User on a Single Node
Note You cannot delete a user who is currently logged in. To log out a user, you can complete the “DLP-D315
Log Out a User on a Single Node” task on page 20-7, or you can choose the “Logout before delete”
option on the Delete User dialog box.
Note CTC will allow you to delete other Superusers only if at least one Superuser remains. For example, you
can delete the CISCO15 user only if you have created another Superuser. Use this option with caution.
Step 1 In node view, select the Provisioning > Security > Users tabs.
Step 2 Choose the user you want to delete.
Step 3 Click Delete.
Step 4 In the Delete User dialog box, verify that the user name displayed is the one you want to delete.
Step 5 Click OK. Confirm that the changes appear; if not, repeat the task.
Step 6 Return to your originating procedure (NTP).
DLP-D160 Change User Password and Security Level on Multiple Nodes
Note You must add the same user name and password to each node the user will access.
Purpose This task deletes an existing user from a single node.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This task modifies existing user settings for multiple nodes.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
