Cisco ONS 15454 SDH - DLP- D493 Provision the Ethernet Port of the ML-Series Card

21-49
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D493 Provision the Ethernet Port of the ML-Series Card
DLP-D493 Provision the Ethernet Port of the ML-Series Card
Step 1 In node view, double-click the ML-Series card where you want to provision the Ethernet port.
Step 2 Click the Provisioning > Ether Ports tabs.
The Ether Ports pane appears.
Step 3 In the Ether Ports pane complete the following:
• Port—Displays a fixed number identifier for the specific port.
• Port Name—Enter a 12 character alphanumeric identifier for the port.
Note Circuit table displays port name of the POS port and not the Ethernet port.
• Admin State—Displays the state of the port. Allowed values are UP and DOWN. For the UP value
to appear, the Ethernet port must be both administratively active and have a SONET/SDH circuit
provisioned.
• PSAS (Pre Service Alarm Suppress)—Check the PSAS checkbox to enable alarm suppression on
the port for a time interval set in the Soak Time column. Uncheck the PSAS checkbox to disbale
alarm suppression.
• Soak Time—Enter a desired soak time in hours and minutes (hh:mm) format. Use this column when
you have checked PSAS to suppress alarms. Once the port detects a signal, the countdown begins
for the designated soak time. Soak time hours can be set from 0 to 48. Soak time minutes can be set
from 0 to 45 in 15 minute increments.
• Link State—Displays the status between signaling points at port and attached device. Allowed
values are UP or DOWN.
• MTU (Maximum Transmission Unit)— Displays the largest acceptable packet size configured for
the port.
• Speed—Displays the Ethernet port transmission speed.
• Duplex—Displays the duplex mode setting for the port.
• Flow Control—Displays the flow control mode negotiated with peer device.
• Optics— Displays the Small form-factor pluggable (SFP) physical media type.
Step 4 Click Apply.
Step 5 Reprovisioning an Ethernet port on the ML-Series card does not reset the ethernet statistics for that port.
The Ethernet Statistics must be refreshed. To do so, do the following:
a. Click the Performance > Ether Ports > Statistics tabs.
b. Click Refresh.
Purpose This task provisions the Ethernet ports of the ML-Series card to carry
traffic.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher