7-4
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 7 Manage Circuits
NTP- D287 Modify and Delete Circuits
NTP-D287 Modify and Delete Circuits
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at a node containing the circuit that you
want to modify. If you are already logged in, continue with Step 2.
Step 2 As needed, complete the “DLP-D230 Change a Circuit State” task on page 19-26.
Step 3 As needed, complete the “DLP-D231 Edit a Circuit Name” task on page 19-27.
Step 4 As needed, complete the “DLP-D232 Change Active and Standby Span Color” task on page 19-28.
Step 5 As needed, complete the “DLP-D233 Edit SNCP Circuit Path Selectors” task on page 19-29.
Step 6 As needed, complete the “DLP-D263 Edit SNCP Dual-Ring Interconnect Circuit Hold-Off Timer” task
on page 19-67.
Step 7 As needed, complete the “DLP-D27 Delete Circuits” task on page 17-21.
Step 8 As needed, complete the “DLP-D80 Change a VCAT Member Service State” task on page 17-72.
Step 9 As needed, complete the “DLP-D76 Add a Member to a VCAT Circuit” task on page 17-67.
Step 10 As needed, complete the “DLP-D77 Delete a Member from a VCAT Circuit” task on page 17-69.
Stop. You have completed this procedure.
NTP-D288 Modify and Delete Overhead Circuits and Server
Trails
Caution Deleting circuits can be service affecting and should be performed during a maintenance window.
Purpose This procedure edits or changes the properties of ONS 15454 SDH circuits
and deletes circuits.
Tools/Equipment None
Prerequisite Procedures Circuits must exist on the network. See Chapter 6, “Create Circuits and
Low-Order Tunnels.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure changes the tunnel type, repairs IP circuits, and deletes
overhead circuits and server trails.
Tools/Equipment None
Prerequisite Procedures Circuits must exist on the network. See Chapter 6, “Create Circuits and
Low-Order Tunnels.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
