20-82
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D393 Switch Between TDM and DWDM Network Views
Step 4 Record on paper the byte that appears in the MS-SPR Ext Byte column.
Step 5 Repeat Steps 2 through 4 for the second OC48 LS/STM16 LH AS trunk card.
Step 6 If the node at the other end of the new span contains OC48 LS/STM16 LH AS trunk cards, repeat Steps 1
through 5 at the node. If it does not have OC48 LS/STM16 LH AS cards, their trunk cards are mapped
to the K3 extension byte. Continue with Step 7.
Step 7 If the trunk cards on each end of the new span are mapped to the same MS-SPRing extension byte,
continue with Step 8. If they are not the same, remap the extension byte of the trunk cards at one of the
nodes. See the “DLP-D89 Remap the K3 Byte” task on page 17-83.
Step 8 Return to your originating procedure (NTP).
DLP-D393 Switch Between TDM and DWDM Network Views
Step 1 From the View menu, choose Go to Network View.
Step 2 From the Network Scope drop-down list, choose one of the following:
• All—Displays both TDM and DWDM nodes.
• TDM—Displays only ONS 15454 SDH nodes with SDH cards including the transponder (TXP) and
muxponder (MXP) cards.
• DWDM—Displays only ONS 15454 SDH nodes with DWDM cards, including the TXP and MXP
cards.
Note For information about DWDM, TXP, and MXP cards, refer to the Cisco ONS 15454 DWDM
Reference Manual.
Step 3 Return to your originating procedure (NTP).
Purpose This task switches the CTC view between time-division multiplexing
(TDM) and DWDM network views. To provision DWDM networks, refer
to the Cisco ONS 15454 DWDM Procedure Guide.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
