Cisco ONS 15454 SDH - As Needed; Step 1; Stop. You Have Completed this Procedure

5-43
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 5 Turn Up a Network
NTP- D172 Create a Logical Network Map
NTP-D172 Create a Logical Network Map
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 on an ONS 15454 SDH on the network
where you want to create the network map. If you are already logged in, continue with Step 2.
Step 2 From the View menu, choose Go to Network View.
Step 3 Change the position of the nodes in the network view according to your site plan.
a. Click a node to select it, then press the Ctrl key while you drag and drop a node icon to a new
location.
b. Repeat Step a for each node you need to position.
Step 4 On the network view map, right-click and choose Save Node Position.
Step 5 Click Yes in the Save Node Position dialog box.
CTC opens a progress bar and saves the new node positions.
Note Retrieve, Provisioning, and Maintenance users can move nodes on the network map, but only
Superusers can save new network map configurations. To restore the view to a previously saved
version of the network map, right-click on the network view map and choose Reset Node
Position.
Stop. You have completed this procedure.
Purpose This procedure allows a Superuser to create a consistent network view for
all nodes on the network.
Tools None
Prerequisite Procedures This procedure assumes that network turn-up is complete.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser