Cisco ONS 15454 SDH - Figure 21-10 Line Drop-Down List for an STM-16 Card

21-35
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D458 Monitor PM Counts for a Selected Signal
Figure 21-10 Line Drop-down List for an STM-16 Card
Step 4 Click Refresh. All PM counts recorded by the near-end or far-end node for the specified outgoing signal
type on the selected card and port appear. For PM parameter definitions, refer to the “Performance
Monitoring” chapter in the Cisco ONS 15454 SDH Reference Manual.
Step 5 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Curr (current) and Prev-n (previous) columns. For PM parameter definitions, refer to the “Performance
Monitoring” chapter in the Cisco ONS 15454 SDH Reference Manual.
Step 6 Return to your originating procedure (NTP).
102020
Directions
radio buttons
Performance
tab
Card View
Intervals
radio buttons
Auto-refreshRefresh
button
Port/Line Baseline
button
Clear
button