Cisco ONS 15454 SDH - Figure 20-5 GBIC Installation (with Clips)

20-31
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D335 Install GBIC or SFP/XFP Devices
• If you are using an SFP, go to Step 6.
Step 4 For GBICs with clips:
a. Grip the sides of the GBIC with your thumb and forefinger and insert the GBIC into the slot on the
card (Figure 20-5).
Note GBICs are keyed to prevent incorrect installation.
Figure 20-5 GBIC Installation (with Clips)
b.
Slide the GBIC through the flap that covers the opening until you hear a click. The click indicates
that the GBIC is locked into the slot.
c. When you are ready to attach the network fiber-optic cable, remove the protective plug from the
GBIC, save the plug for future use, and install the fiber connector.
d. Continue with Step 8.
Step 5 For GBICs with a handle:
a. Remove the protective plug from the SC-type connector.
E1000
2
FAIL
ACT
1
SF
33678 12931
2
RX
TX
RX
TX
ACT/LINK
ACT/LINK
44734
Plug