Cisco ONS 15454 SDH - DLP- D462 View FC_MR-4 History PM Parameters

21-39
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D462 View FC_MR-4 History PM Parameters
DLP-D462 View FC_MR-4 History PM Parameters
Step 1 In node view, double-click the FC_MR-4 card where you want to view PM counts. The card view
appears.
Step 2 Click the Performance > History tabs (Figure 21-13).
Figure 21-13 FC_MR-4 History in the Card View Performance Window
Step 3
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Prev-n columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 SDH Reference Manual.
Step 5 Return to your originating procedure (NTP).
Purpose This task enables you to view historical PM counts at selected time
intervals on an FC_MR-4 card and port to detect possible performance
problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
124914
History tab
Performance
tab
Card View
Refresh
button
Port
drop-down
list
Interval
drop-down
list