9-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 9 Manage Alarms
NTP- D195 Document Existing Provisioning
NTP-D195 Document Existing Provisioning
Step 1 Complete “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to record or save
data. If you are already logged in, continue with Step 2.
Step 2 As needed, complete the “DLP-D146 Print CTC Data” task on page 18-37.
Step 3 As needed, complete the “DLP-D147 Export CTC Data” task on page 18-38.
Stop. You have completed this procedure.
NTP-D196 View Alarms, History, Events, and Conditions
Step 1 Complete “DLP-D60 Log into CTC” task on page 17-49 at the node that contains the alarms you want
to view. If you are already logged in, continue with Step 2.
Step 2 Complete the “DLP-D82 View Alarms” task on page 17-74 as needed.
Step 3 Complete the “DLP-D424 View Alarm or Event History” task on page 21-4 as needed.
Step 4 Complete the “DLP-D111 Changing the Maximum Number of Session Entries for Alarm History” task
on page 18-14 as needed.
Step 5 Complete the “DLP-D112 Display Alarms and Conditions Using Time Zone” task on page 18-15 as
needed.
Step 6 Complete the “DLP-D113 Synchronize Alarms” task on page 18-15 as needed.
Purpose Use this procedure to print or export card, node, or network CTC
information in graphical or tabular form on a Windows-provisioned
printer. This procedure is useful for network record keeping and
troubleshooting.
Tools/Equipment A printer connected to the CTC computer by a direct or network
connection.
Prerequisite Procedures Chapter 4, “Turn Up a Node”
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose Use this procedure to view current or historical alarms and conditions for
a card, node, or network. This information is useful for monitoring and
troubleshooting hardware and software events.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
