1-19
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 1 Install the Shelf and FMECs
NTP- D13 Perform the Shelf Installation Acceptance Test
Step 2 Complete the “DLP-D32 Inspect the Shelf Installation and Connections” task on page 17-26.
Step 3 Complete the “DLP-D33 Measure Voltage” task on page 17-26.
Step 4 Continue with Chapter 2, “Install Cards and Fiber-Optic Cable.”
Stop. You have completed this procedure.
Table 1-2 ONS 15454 SDH Shelf Installation Task Summary
Description Completed
NTP-D1 Unpack and Inspect the ONS 15454 SDH Shelf Assembly, page 1-4
NTP-D2 Install the Shelf Assembly, page 1-5
NTP-D3 Open and Remove the Front Door, page 1-6
NTP-D219 Open and Remove the FMEC Cover, page 1-7
NTP-D220 Install the Power and Signal FMECs, page 1-7
NTP-D6 Install the Power and Ground, page 1-10
NTP-D7 Install the Fan-Tray Assembly, page 1-11
NTP-D222 Install the E1-75/120 Conversion Panel, page 1-13
NTP-D223 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections,
page 1-15
NTP-D224 Install the Electrical Card Cables on the FMECs, page 1-16
NTP-D10 Route Electrical Cables, page 1-16
NTP-D226 Install and Close the FMEC Cover, page 1-17
To Next Page
Loading...
