17-19
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D23 View Spanning Tree Information
DLP-D23 View Spanning Tree Information
Step 1 In node view, click the Maintenance > EtherBridge > Circuits tabs.
Step 2 In the EtherBridge Circuits window, you can view the following information:
• Type—Identifies the type of Ethernet circuit mapped to the spanning tree, such as EtherSwitch
point-to-point.
• Circuit Name/Port—Identifies the circuit name for the circuit in the spanning tree. This column also
lists the Ethernet slots and ports mapped to the spanning tree for the node.
• STP ID—Shows the Spanning Tree Protocol ID number.
• VLANS—Lists the VLANs associated with the circuit or port.
Step 3 Return to your originating procedure (NTP).
DLP-D24 Change an MS-SPRing Node ID
Step 1 From the View menu, choose Go to Network View.
Step 2 On the network map, double-click the node with the node ID you want to change.
Step 3 Click the Provisioning > MS-SPRing tabs.
Step 4 Choose a Node ID number. Do not choose a number already assigned to another node in the same
MS-SPRing.
Step 5 Click Apply.
Purpose This task allows you to view E-Series Ethernet circuits and the Ethernet
front ports operating with Spanning Tree Protocol (STP). The E-Series
cards support up to eight STPs per node. For more information about STP,
refer to the Ethernet Software Feature and Configuration Guide for the
Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This task changes an MS-SPRing node ID.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
