15-8
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 15 Maintain the Node
NTP- D328 View and Manage OSI Information
Caution Opening a restore file from another node or from an earlier backup might affect traffic on the login node.
Step 10 Click Restore.
The Restore Database dialog box monitors the file transfer (Figure 15-3).
Figure 15-3 Restoring the Database—In-Process Notification
Step 11
Wait for the file to complete the transfer to the TCC2/TCC2P card.
Step 12 Click OK when the “Lost connection to node, changing to Network View” dialog box appears. Wait for
the node to reconnect.
Step 13 If you cleared a switch in Step 3, reapply the switch as needed.
Stop. You have completed this procedure.
NTP-D328 View and Manage OSI Information
Note Additional information about the ONS 15454 SDH implementation of OSI is provided in the
“Management Network Connectivity” chapter of the Cisco ONS 15454 SDH Reference Manual.
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Perform any of the following tasks as needed:
• DLP-D183 View IS-IS Routing Information Base, page 18-70
Purpose This procedure allows you to view and manage Open System
Interconnection (OSI), including the End System-to-Intermediate System
(ES-IS) and Intermediate System-to-Intermediate System (IS-IS) routing
information tables, Target Identifier Address Resolution Protocol (TARP)
data cache, and manual area table.
Tools/Equipment None
Prerequisite Procedures NTP-D108 Back Up the Database, page 15-5
NTP-D278 Set Up Computer for CTC, page 3-2
NTP-D326 Provision OSI, page 4-14
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
