18-85
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D198 Clear an SNCP Force Switch
DLP-D198 Clear an SNCP Force Switch
Step 1 From the View menu in node view, choose Go to Network View.
Step 2 Right-click the span where you want to clear the switch. Choose Circuits from the shortcut menu.
Step 3 In the Circuits on Span dialog box, choose CLEAR to remove the Force switch. Click Apply.
Step 4 In the Confirm SNCP Switch dialog box, click Yes .
Step 5 In the Protection Switch Result dialog box, click OK.
In the Circuits on Span window, the Switch State for all SNCP circuits is CLEAR.
Step 6 Return to your originating procedure (NTP).
Purpose This task clears an SNCP Force switch.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
