Cisco ONS 15454 SDH - NTP- D229 Replace an In-Service Cross-Connect Card

15-21
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 15 Maintain the Node
NTP- D229 Replace an In-Service Cross-Connect Card
Stop. You have completed this procedure.
NTP-D229 Replace an In-Service Cross-Connect Card
Warning Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard. Statement 206
Caution Removing any active card from the ONS 15454 SDH can result in traffic interruption. Use caution when
replacing cards and verify that only standby cards are being replaced. An improper removal
(IMPROPRMVL) alarm is raised when a card reseat is performed, unless the card is first deleted in CTC.
The alarm clears after the card replacement is complete.
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to replace the
card.
Step 2 From the View menu, choose Go to Network View.
Step 3 Click the Alarms tab and complete the following substeps:
a. Verify that the alarm filter is not on. See the “DLP-D227 Disable Alarm Filtering” task on
page 19-25 as necessary.
SSM
Quality
Indicates the
SSM timing
quality.
8 to 10 SSM quality messages
might be displayed.
For a list of SSM message sets, see the “Timing” chapter
in the Cisco ONS 15454 SDH Reference Manual.
SSM
Changed
Indicates the
date and time of
the last SSM
status change in
MM/DD/YY
HH:MM:SS
format.
——
Table 15-2 ONS 15454 SDH Timing Report (continued)
Item Description Options Option Descriptions
Purpose This procedure replaces an in-service (Unlocked-enabled)
cross-connect card.
Tools/Equipment None
Prerequisite Procedures DLP-D333 Install the XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G
Cards, page 20-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher