Cisco ONS 15454 SDH - NTP- D301 Monitor FC_MR-4 Performance

8-6
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 8 Monitor Performance
NTP- D301 Monitor FC_MR-4 Performance
Note To refresh, reset, or clear PM counts, see the “NTP-D257 Change the PM Display” procedure on
page 8-2.
Stop. You have completed this procedure.
NTP-D301 Monitor FC_MR-4 Performance
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node that you want to monitor. If you
are already logged in, continue with Step 2.
Step 2 Complete the “DLP-D460 View FC_MR-4 Statistics PM Parameters” task on page 21-37.
Step 3 Complete the “DLP-D461 View FC_MR-4 Utilization PM Parameters” task on page 21-38.
Step 4 Complete the “DLP-D462 View FC_MR-4 History PM Parameters” task on page 21-39.
Stop. You have completed this procedure.
NTP-D302 Create or Delete FC_MR-4 RMON Thresholds
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Purpose This procedure enables you to view node transmit and receive
performance during selected time intervals on an FC_MR-4 card and
port to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see Chapter 6, “Create Circuits
and Low-Order Tunnels” and Chapter 10, “Change Card Settings.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This procedure creates or deletes FC_MR-4 RMON thresholds for the
ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher