Cisco ONS 15454 SDH - DLP- D427 Delete Alarm Severity Profiles

21-11
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D427 Delete Alarm Severity Profiles
DLP-D427 Delete Alarm Severity Profiles
Step 1 Access the alarm profile editor:
• From network view, click the Provisioning > Alarm Profiles tabs.
• From node view, click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
• From card view, if the card is an FC_MR-4, E-Series Ethernet, G-Series Ethernet, STM-N, or
electrical (DS3i-N-12, E-1, E1-42, or E-3) card, click the Provisioning > Alarm Profiles >
Alarm Profile Editor tabs.
• If the card is an ML-Series Ethernet (traffic) card, click the Provisioning > Ether Alarming >
Alarm Profile Editor tabs or the Provisioning > POS Alarming > Alarm Profile Editor tabs,
depending on whether you want to apply the profile to the front physical ports (“Ether alarming”)
or packet over SDH (“POS alarming”). For more information about ML-Series card ports and
service, see the Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454,
Cisco ONS 15454 SDH, and Cisco ONS 15327.
Step 2 Click the profile you are deleting to select it.
Step 3 Click Delete.
The Select Node/Profile Combination for Delete dialog box appears (Figure 21-5).
Figure 21-5 Select Node/Profile Combination For Delete Dialog Box
Note You cannot delete the Inherited or Default alarm profiles.
Purpose This task deletes a custom or default alarm severity profile.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher