17-96
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D98 Provision a High-Order Circuit Route
Step 4 If you need to create a secondary source, for example, an SNCP ring bridge/selector circuit entry point
in a multivendor SNCP ring, click Use Secondary Source and repeat Steps 1 through 3 to define the
secondary source.
Step 5 Click Next.
Step 6 From the Node drop-down list, choose the destination node.
Step 7 From the Slot drop-down list, choose the slot containing the optical card where the circuit will terminate
(destination card). (If a card’s capacity is fully utilized, the card does not appear in the list.)
Step 8 Depending on the card selected in Step 2, choose the destination port and/or VC-4 from the Port and
VC-4 drop-down lists. The Port drop-down list is available only if the card has multiple ports. The VC-4s
that appear depend on the card, circuit size, and protection scheme.
Step 9 If you need to create a secondary destination, for example, an SNCP ring bridge/selector circuit entry
point in a multivendor SNCP ring, click Use Secondary Destination and repeat Steps 6 through 8 to
define the secondary destination.
Step 10 Click Next.
Step 11 Return to your originating procedure (NTP).
DLP-D98 Provision a High-Order Circuit Route
Step 1 In Route Review/Edit area of the Circuit Creation wizard, click the source node icon if it is not already
selected.
Step 2 Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
arrow turns white. In the Selected Span area, the From and To fields show span information. The source
VC-4 appears. Figure 17-18 shows an example.
Purpose This task provisions a high-order circuit route for manually routed circuits.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
NTP-D324 Create a Manually Routed High-Order Circuit, page 6-60
You must have the Route Review/Edit page of the Circuit Creation wizard
open.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
