Cisco ONS 15454 SDH - NTP- D241 Provision G-Series Ports for Transponder Mode

6-92
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D241 Provision G-Series Ports for Transponder Mode
b. From the Slot drop-down list, choose the Ethernet card that will be the cross-connect source.
c. From the Port drop-down list, choose the cross-connect source port.
Step 12 Click Next.
Step 13 Provision the circuit destination:
a. From the Node drop-down list, choose the cross-connect source node selected in Step 11. (For
Ethernet cross-connects, the source and destination nodes are the same.)
b. From the Slot drop-down list, choose the STM-N card that connects to the non-ONS equipment.
c. Depending on the STM-N card, choose the port and VC4 from the Port and VC4 drop-down lists.
Step 14 Click Next.
Step 15 Verify the cross-connect information (in this step, “circuit” refers to the cross-connect):
• Circuit name
• Circuit type
• Circuit size
• ONS 15454 SDH circuit nodes
If the information is not correct, click the Back button and repeat the procedure with the correct
information. If the information is correct, check Route Automatically.
Step 16 Complete the “NTP-D149 Test G-Series Circuits” procedure on page 6-95 for a G-Series card, or
complete the “NTP-D146 Test E-Series Circuits” procedure on page 6-89 for an E-Series card.
Step 17 Click Finish.
Stop. You have completed this procedure.
NTP-D241 Provision G-Series Ports for Transponder Mode
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you will provision
G-Series ports. If you are already logged in, continue with Step 2.
Step 2 In the node view, double-click the G-Series card graphic to open the card.
Step 3 Click the Provisioning > Port tabs.
Step 4 To put a pair of G-Series card ports in two-port bidirectional transponder mode (Figure 6-10):
Purpose This task provisions G-Series ports for transponder mode.
Tools/Equipment None
Prerequisite Procedures DLP-D222 Provision G-Series Ethernet Ports, page 19-21
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher