20-58
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D353 Provision G-Series Flow Control Watermarks
Figure 20-12 POS Ports on the Card View Performance Window
Step 3
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Port # columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note To refresh, reset, or clear PM counts, see the “NTP-D257 Change the PM Display” procedure
on page 8-2.
Step 5 Return to your originating procedure (NTP).
DLP-D353 Provision G-Series Flow Control Watermarks
Step 1 In node view, double-click the G-Series card graphic to open the card.
124921
POS Ports
tab
Performance
tab
Card View
Auto-refreshRefresh
button
Baseline
button
Purpose This task provisions the buffer memory levels for flow control on G-Series
Ethernet ports.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
