Cisco ONS 15454 SDH - DLP- D80 Change a VCAT Member Service State

17-72
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D80 Change a VCAT Member Service State
Step 7 Click the Filter button.
Step 8 Type the slot and port of a trunk card on the removed node.
Step 9 Click OK.
Step 10 In the Circuits tab, select all PARTIAL circuits that pass the filter and click the Delete button.
Note To select more than one circuit, press the Shift key and simultaneously click on all circuits to be
deleted.
Step 11 Repeat Steps 6 through 10 for the other trunk card.
Step 12 Log out of CTC.
Step 13 Return to your originating procedure (NTP).
DLP-D80 Change a VCAT Member Service State
Note CTC only permits you to change the state of a non-LCAS member if the new state matches the In Group
VCAT state of the other members or if the new state is an Out of Group VCAT state. An In Group VCAT
member has cross-connects in the Unlocked-enabled; Unlocked-disabled,automaticInService; or
Locked-enabled,Maintenance service states. For non-LCAS VCAT members, the Out of Group VCAT
state is the Locked-enabled,disabled service state.
Step 1 In node or network view, click the Circuits tab.
Step 2 Click the VCAT circuit that you want to edit, then click Edit.
Step 3 Click the Members tab.
Step 4 Select the member that you want to change. To choose multiple members, press Ctrl and click each
member.
Step 5 From the Tools menu, choose Set Circuit State.
Note You can also change the state for all members listed in the Edit Circuit window using the State
tab. Another alternative is to click the Edit Member button to access the Edit Member Circuit
window for the selected member, and then click the State tab.
Purpose This task displays the Edit Circuit window for VCAT members, where you
can change the service state.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
VCAT circuits must exist on the network. See Chapter 6, “Create Circuits
and Low-Order Tunnels.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher