Cisco ONS 15454 SDH - Unable to Verify the NIC Connection on Your PC

CHAPTER
4-1
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
4
Turn Up a Node
This chapter explains how to provision a single Cisco ONS 15454 SDH node and turn it up for service,
including node name, date and time, timing references, network attributes such as IP address and default
router, users and user security, and card protection groups.
Before You Begin
Complete the procedures applicable to your site plan from the following chapters:
• Chapter 1, “Install the Shelf and FMECs”
• Chapter 2, “Install Cards and Fiber-Optic Cable”
• Chapter 3, “Connect the PC and Log into the GUI”
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1. NTP-D24 Verify Card Installation, page 4-2—Complete this procedure first.
2. NTP-D30 Create Users and Assign Security, page 4-4—Continue with this procedure to create
Cisco Transport Controller (CTC) users and assign their security levels.
3. NTP-D316 Set Up Name, Date, Time, and Contact Information, page 4-4—Continue with this
procedure to set the node name, date, time, location, and contact information.
4. NTP-D279 Set Power Monitor Thresholds, page 4-6—Continue with this procedure to set the node
battery power thresholds.
5. NTP-D169 Set Up CTC Network Access, page 4-7—Continue with this procedure to provision the
IP address, default router, subnet mask, and network configuration settings.
6. NTP-A360 Enable EMS Secure Access, page 4-8—Continue with this procedure to enable EMS
secure access and provide enhanced SFTP and SSH security.
7. NTP-D27 Set Up the ONS 15454 SDH for Firewall Access, page 4-8—Continue with this procedure
if the ONS 15454 SDH will be accessed behind firewalls.
8. NTP-D28 Set Up Timing, page 4-9—Continue with this procedure to set up the node’s SDH timing
references.
9. NTP-D170 Create Protection Groups, page 4-10—Complete this procedure, as needed, to set up 1:1,
1:N, or 1+1 protection groups for ONS 15454 SDH electrical and optical cards.
10. NTP-D34 Set Up SNMP, page 4-12—Complete this procedure if Simple Network Management
Protocol (SNMP) will be used for network monitoring.