Cisco ONS 15454 SDH - Facility Loopbacks

iii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
CONTENTS
About this Guide xiii
Revision History xiv
Document Objectives xv
Audience xv
Document Organization xv
Chapter (Director Level) xvi
Non-Trouble Procedure (NTP) xviii
Detailed Level Procedure (DLP) xviii
Related Documentation xviii
Document Conventions xviii
Obtaining Optical Networking Information xxv
Where to Find Safety and Warning Information xxv
Cisco Optical Networking Product Documentation CD-ROM xxv
Obtaining Documentation and Submitting a Service Request xxv
CHAPTER 1 Install the Shelf and FMECs 1-1
Before You Begin 1-1
Required Tools and Equipment 1-2
Cisco-Supplied Equipment 1-2
User-Supplied Equipment 1-3
Tools Needed 1-4
Test Equipment 1-4
NTP- D1 Unpack and Inspect the ONS 15454 SDH Shelf Assembly 1-4
NTP- D2 Install the Shelf Assembly 1-5
NTP- D3 Open and Remove the Front Door 1-6
NTP- D219 Open and Remove the FMEC Cover 1-7
NTP- D220 Install the Power and Signal FMECs 1-7
NTP- D6 Install the Power and Ground 1-10
NTP- D7 Install the Fan-Tray Assembly 1-11
NTP- D222 Install the E1-75/120 Conversion Panel 1-13
NTP- D223 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections 1-15
NTP- D224 Install the Electrical Card Cables on the FMECs 1-16
NTP- D10 Route Electrical Cables 1-16