Cisco ONS 15454 SDH - Page 4

Contents
iv
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP- D226 Install and Close the FMEC Cover 1-17
NTP- D13 Perform the Shelf Installation Acceptance Test 1-18
CHAPTER 2 Install Cards and Fiber-Optic Cable 2-1
Before You Begin 2-1
NTP- D15 Install the Common Control Cards 2-2
NTP- D16 Install STM-N Cards and Connectors 2-7
NTP- D17 Install the Electrical Cards 2-10
NTP- D18 Install Ethernet Cards and Connectors 2-11
NTP- D286 Install the FC_MR-4 Cards 2-12
NTP- D348 Install the Filler Cards 2-14
NTP- D349 Install the Blank Faceplates 2-15
NTP- D19 Install Fiber-Optic Cables on Optical Cards 2-16
NTP- D245 Route Fiber-Optic Cables 2-19
NTP- D227 Remove and Replace a Card 2-20
NTP- D20 Replace the Front Door 2-21
CHAPTER 3 Connect the PC and Log into the GUI 3-1
Before You Begin 3-1
NTP- D278 Set Up Computer for CTC 3-2
NTP- D260 Set Up CTC Computer for Local Craft Connection to the ONS 15454 SDH 3-3
NTP- D261 Set Up a Computer for a Corporate LAN Connection to the ONS 15454 SDH 3-5
NTP- D262 Set Up a Remote Access Connection to the ONS 15454 SDH 3-6
NTP- D23 Log into the ONS 15454 SDH GUI 3-7
CHAPTER 4 Turn Up a Node 4-1
Before You Begin 4-1
NTP- D24 Verify Card Installation 4-2
NTP- D30 Create Users and Assign Security 4-4
NTP- D316 Set Up Name, Date, Time, and Contact Information 4-4
NTP- D279 Set Power Monitor Thresholds 4-6
NTP- D169 Set Up CTC Network Access 4-7
NTP- A360 Enable EMS Secure Access 4-8
NTP- D27 Set Up the ONS 15454 SDH for Firewall Access 4-8
NTP- D28 Set Up Timing 4-9
NTP- D170 Create Protection Groups 4-10