Cisco ONS 15454 SDH - Page 105

2-19
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 2 Install Cards and Fiber-Optic Cable
NTP- D245 Route Fiber-Optic Cables
NTP-D245 Route Fiber-Optic Cables
Step 1 As needed, complete the “DLP-D45 Install the Fiber Boot” task on page 17-35. Fiber boots are required
for all STM-N cards except the STM-64, OC192SR1/STM64IO Short Reach, OC192/STM64 Any Reach
(STM64-XFP), and STM-16 AS cards.
Step 2 Open the fold-down front door on the cable-management tray (Figure 2-2).
Figure 2-2 Fold-Down Front Door of the Cable-Management Tray
Step 3
Route the fiber cable on the card faceplate through the fiber clip on the faceplate (Figure 2-3). Fiber clips
are factory-attached to the faceplate of the STM-N cards.
Step 4 If you installed a 15454_MRC-12 card, complete the “DLP-D104 Install the Fiber Clip on
15454_MRC-12 Cards” task on page 18-3. The 15454_MRC-12 cards are shipped with two versions of
a fiber clip that plug into the faceplate. The clip must be selected according to the cabinet door depth.
Use the short clip with the standard door and the long clip with the extended door.
GBICs, SFPs, and XFPs do not have fiber clips; therefore, if you are routing optical cable from an
FC_MR-4, E1000-2-G, G1K-4, ML1000-2, or STM64-XFP cards, skip to Step 5.
Purpose This procedure routes fiber-optic cables.
Tools/Equipment None
Prerequisite Procedures NTP-D19 Install Fiber-Optic Cables on Optical Cards, page 2-16
NTP-D286 Install the FC_MR-4 Cards, page 2-12
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
F
A
N
F
A
IL
C
R
IT
M
A
J
M
IN
78100