2-12
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 2 Install Cards and Fiber-Optic Cable
NTP- D286 Install the FC_MR-4 Cards
Warning
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
not view directly with optical instruments. Viewing the laser output with certain optical instruments
(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye
hazard.
Statement 1056
Caution Always use the supplied ESD wristband when working with a powered ONS 15454 SDH. Plug the
wristband cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Note Cisco recommends installing TXP, MXP, STM-N, and electrical cards before you install Ethernet cards,
as applicable.
Step 1 If you installed XC-VXL-2.5G cards, review Table 2-1 on page 2-3 to determine card/slot compatibility.
If you installed XC-VXL-10G or XC-VXC-10G cards, review Table 2-2 on page 2-5 to determine
card/slot compatibility.
Step 2 Complete the “DLP-D39 Install Ethernet Cards” task on page 17-30. Allow each card to boot completely
before installing the next card.
Step 3 Complete the “DLP-D335 Install GBIC or SFP/XFP Devices” task on page 20-28 if you are using
E1000-2-G, G1K-4, ML1000-2, ML100X-8, or CE-1000-4 cards.
Note If you need to remove a Gigabit Interface Converter (GBIC) or SFP/XFP, complete the
“DLP-D336 Remove GBIC or SFP/XFP Device” task on page 20-32.
Step 4 Continue with “NTP-D286 Install the FC_MR-4 Cards” procedure on page 2-12 if necessary.
Stop. You have completed this procedure.
NTP-D286 Install the FC_MR-4 Cards
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
Purpose This procedure installs the FC_MR-4 card, also known as the
Fibre Channel card.
Tools/Equipment FC_MR-4 card(s)
Prerequisite Procedures NTP-D15 Install the Common Control Cards, page 2-2
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
