18-12
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D109 Change Optics Thresholds Settings for STM-64 and MRC-12 Cards
Step 5 Return to your originating procedure (NTP).
DLP-D109 Change Optics Thresholds Settings for STM-64 and MRC-12 Cards
Step 1 In node view, double-click the card where you want to change the optics settings.
Step 2 Click the Provisioning > Optics Thresholds tabs.
Reach (Does not apply to all cards) Allows you to
provision the reach value. You can also choose
Auto Provision, which allows the system to
automatically provision the reach from the PPM
reach value on the hardware.
The options that appear in the drop-down list depend on
the card:
• SR (short reach, up to 2 km distance)
• SR-1 (up to 2 km distance)
• IR-1 (intermediate reach, up to 15 km distance)
• IR-2 (up to 40 km distance)
• LR-1 (long reach, up to 40 km distance)
• LR-2 (up to 80 km distance)
• LR-3 (up to 80 km distance)
Wavelength (Does not apply to all cards) Allows you to
provision the wavelength frequency.
• First Tunable Wavelength
• 1310 nm
• 1550 nm
• 1470 nm
• 1490 nm
• 1510 nm
• 1530 nm
• 1570 nm
• 1590 nm
• 1610 nm
Purpose This task changes the optics thresholds settings for STM-64 and MRC-12
cards.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 18-1 STM-N Card Line Settings (continued)
Parameter Description Options
To Next Page
Loading...
