17-20
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D25 Configure the CTC Alerts Dialog Box for Automatic Popup
Step 6 Return to your originating procedure (NTP).
DLP-D25 Configure the CTC Alerts Dialog Box for Automatic Popup
Step 1 Click the CTC Alerts toolbar icon.
Step 2 In the CTC Alerts dialog box, choose one of the following:
• All alerts—Sets the CTC Alerts dialog box to open automatically for all notifications.
• Error alerts only—Sets the CTC Alerts dialog box to open automatically for circuit deletion errors
only.
• Never—Sets the CTC Alerts dialog box to never open automatically.
Step 3 Click Close.
Step 4 Return to your originating procedure (NTP).
DLP-D26 Provision a VCAT Circuit Route
Step 1 In the Circuit Creation wizard in the Route Review and Edit area, choose the member number from the
Route Member Number drop-down list.
Step 2 Click the source node icon if it is not already selected.
Purpose This task sets the CTC Alerts dialog box to open for all alerts, for circuit
deletion errors only, or never. The CTC Alerts dialog box displays network
disconnection, Send-PDIP inconsistency, circuit deletion status, condition
retrieval errors, and software download failure.
Tools None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task provisions the circuit route for manually routed STM-N circuits.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
You must have the Route Review and Edit page of the Circuit Creation
wizard open.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
