18-15
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D112 Display Alarms and Conditions Using Time Zone
Note This task changes the maximum history entries recorded for CTC sessions. It does not affect the
maximum number of history entries viewable for a network, node, or card.
Step 4 Return to your originating procedure (NTP).
DLP-D112 Display Alarms and Conditions Using Time Zone
Step 1 From the Edit menu, choose Preferences.
The CTC Preferences dialog box appears (Figure 18-4 on page 18-14).
Step 2 Check the Display Events Using Each Node’s Time Zone check box. The Apply button is enabled.
Step 3 Click Apply and OK.
Step 4 Return to your originating procedure (NTP).
DLP-D113 Synchronize Alarms
Step 1 At the card, node, or network view, click the Alarms tab.
Step 2 Click Synchronize.
This button causes CTC to retrieve a current alarm summary for the card, node, or network. This step is
optional because CTC updates the Alarms window automatically as raise/clear messages arrive from the
node.
Purpose This task changes the time stamp for events to the time zone of the ONS
node reporting the alarm. By default, the events time stamp is set to the
time zone for the CTC workstation.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Purpose Use this task to view ONS 15454 SDH events at the card, node, or network
level and to refresh the alarm listing so that you can check for new and
cleared alarms and conditions.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
