15-25
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 15 Maintain the Node
NTP- D345 Edit Network Element Defaults
Step 10 To verify that the tray has plugged into the backplane, check that the LCD on the front of the fan tray is
activated.
Step 11 Replace the door and reattach the ground strap.
Stop. You have completed this procedure.
NTP-D345 Edit Network Element Defaults
Note For a list of card and node default settings, refer to the “Network Element Defaults” appendix in the
Cisco ONS 15454 SDH Reference Manual. To change card settings individually (that is, without
changing the defaults), see Chapter 10, “Change Card Settings.” To change node settings, see
Chapter 11, “Change Node Settings.”
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 CTC at the node where you want to edit NE
defaults.
Step 2 Click the Provisioning > Defaults tabs.
Step 3 Under Defaults Selector, choose a card type (if editing card-level defaults), CTC (if editing CTC
defaults), or NODE (if editing node-level defaults). Click the node name (at the top of the Defaults
Selector column) to display all available NE defaults in the Default Name column. To selectively display
just the defaults for a given card type, for node-level, or for CTC-level, you can drill down the Defaults
Selector menu structure.
Step 4 Locate a default that you want to change in the Default Name column.
Step 5 Click the Default Value column for the default property you are changing and either choose a value from
the drop-down list (when available), or type the desired new value.
Note If you click Reset before you click Apply, all values will return to their original settings.
Step 6 Click Apply. (If it is unavailable, click in the Default Name column to activate the button.) You can
modify multiple default values before applying the changes.
A pencil icon will appear next to any default value that will be changed as a result of editing the defaults
file.
Purpose This procedure edits factory-configured NE defaults using the NE Defaults
editor. The new defaults can either be applied only to the node on which
they are edited or exported to a file and imported for use on other nodes.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
