17-22
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D28 Create a Four-Fiber MS-SPRing Manually
Step 5 Click the Circuits tab.
Step 6 Choose the circuits that you want to delete, then click Delete.
Step 7 In the Delete Circuits confirmation dialog box, check one or both of the following, as needed:
• Set drop ports to Locked,disabled—Puts the circuit source and destination ports out of service if the
circuit is the same size as the port or is the only circuit using the port. If the circuit is not the same
size as the port or the only circuit using the port, CTC does not change the port service state.
• Notify when completed—If checked, the CTC Alerts dialog box will indicate when all circuit
source/destination ports are Locked,disabled and the circuit is deleted. During this time, you cannot
perform other CTC functions. If you are deleting many circuits, waiting for confirmation might take
a few minutes. Circuits are deleted whether or not this check box is checked.
Note The CTC Alerts dialog box will not automatically open to show a deletion error unless you
checked All alerts or Error alerts only in the CTC Alerts check box. For more information,
see the “DLP-D25 Configure the CTC Alerts Dialog Box for Automatic Popup” task on
page 17-20. If the CTC Alerts dialog box is not set to open automatically with a notification,
the red triangle inside the CTC Alerts toolbar icon indicates that a notification exists.
Step 8 Complete one of the following:
• If you checked Notify when completed, the CTC Alerts dialog box appears. If you want to save the
information, continue with Step 9. If you do not want to save the information, continue with Step 10.
• If you did not check Notify when completed, the Circuits window appears. Continue with Step 11.
Step 9 If you want to save the information in the CTC Alerts dialog box, complete the following steps. If you
do not want to save the information, continue with the next step.
a. Click Save.
b. Click Browse and navigate to the directory where you want to save the file.
c. Type the file name using a .txt file extension, and click OK.
Step 10 Click Close to close the CTC Alerts dialog box.
Step 11 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Step 12 Return to your originating procedure (NTP).
DLP-D28 Create a Four-Fiber MS-SPRing Manually
Step 1 In node view, click the Provisioning > Ring tabs.
Purpose This task creates a four-fiber MS-SPRing at each MS-SPRing-provisioned
node without using the MS-SPRing wizard.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
