Cisco ONS 15454 SDH - DLP- D463 Refresh FC_MR-4 PM Counts at a Different Time Interval

21-40
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D463 Refresh FC_MR-4 PM Counts at a Different Time Interval
DLP-D463 Refresh FC_MR-4 PM Counts at a Different Time Interval
Step 1 In node view, double-click the FC_MR-4 card where you want to view PM counts. The card view
appears.
Step 2 Click the Performance tab.
Step 3 Click the Utilization or the History tab.
Step 4 From the Interval drop-down list, choose one of four options:
• 1 min—This option displays the specified PM counts in one-minute time intervals.
• 15 min—This option displays the specified PM counts in 15-minute time intervals.
• 1 hour—This option displays the specified PM counts in one-hour time intervals.
• 1 day—This option displays the specified PM counts in one-day (24 hours) time intervals.
Step 5 Click Refresh. The PM counts refresh with values based on the selected time interval.
Step 6 Return to your originating procedure (NTP).
DLP-D465 Create FC_MR-4 RMON Alarm Thresholds
Step 1 In node view, double-click the FC_MR-4 card where you want to create the RMON alarm thresholds.
Step 2 In card view, click the Provisioning > RMON Thresholds tabs.
Step 3 Click Create. The Create Threshold dialog box appears.
Step 4 From the Slot drop-down list, choose the appropriate FC_MR-4 card.
Step 5 From the Port drop-down list, choose the applicable port on the FC_MR-4 card you selected.
Purpose This task changes the window view to display specified PM counts in
time intervals depending on the interval option selected.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This procedure sets up RMON to allow network management systems
(NMSs) to monitor FC_MR-4 ports.
Tools/Equipment None
Prerequisite Procedures NTP-D24 Verify Card Installation, page 4-2
DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher