17-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D2 Inspect the Shelf Assembly
DLP-D2 Inspect the Shelf Assembly
Step 1 Open the shelf using the pinned hex key. For more information, see the “DLP-D8 Open the Front Cabinet
Compartment (Door)” task on page 17-9.
Step 2 Verify the following:
• Pins are not bent or broken.
• The frame is not bent.
Step 3 If the pins are bent or broken, or the frame is bent, call your Cisco sales engineer for a replacement.
Step 4 Close the front door before installing.
Step 5 Return to your originating procedure (NTP).
DLP-D3 Provision a Low-Order VC12 Circuit Route
Step 1 In the Circuit Creation wizard in the Route Review and Edit area, click the source node icon if it is not
already selected.
Step 2 Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
arrow turns white. In the Selected Span area, the From and To fields provide span information. The
source VC12 appears.
Step 3 If you want to change the source VC12, adjust the Source VC12 field; otherwise, continue with Step 4.
Step 4 If you want to change the source TUG2, TUG3, VC3, or VC4, adjust the TUG2, TUG3, VC3, or VC4
fields; otherwise, continue with Step 5.
Purpose This task verifies that all parts of the shelf assembly are in good condition.
Tools/Equipment Pinned hex (Allen) key for front door
Prerequisite Procedures DLP-D1 Unpack and Verify the Shelf Assembly, page 17-1
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
Purpose This task provisions the circuit route for low-order VC12 manually routed
circuits.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
NTP-D335 Create a Manually Routed Low-Order VC11 Circuit, page 6-12
You must have the Route Review and Edit page of the Circuit Creation
wizard open.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
