6-90
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D148 Create a Manual Cross-Connect for a G-Series or E-Series Card in Port-Mapped Mode
Note At this point, you are not able to send and receive Ethernet traffic.
Step 8 At the source node, connect an Ethernet test set to the source port and configure the test set to send and
receive the appropriate Ethernet traffic.
Step 9 Transmit Ethernet frames between both test sets. If you cannot transmit and receive Ethernet traffic
between the nodes, repeat Steps 2 through 8 to make sure that you configured the Ethernet ports and test
set correctly.
Step 10 Perform protection switch testing appropriate to the topology:
• For SNCP rings, see the “DLP-D94 SNCP Protection Switching Test” task on page 17-91
• For MS-SPRings see the “DLP-D91 MS-SPRing Switch Test” task on page 17-84.
Configure your test set according to local site practice. For information about configuring your test set,
see your test set user guide.
Step 11 After the Ethernet test is complete, print the results or save them to a disk for future reference. For
information about printing or saving test results, see your test set user guide.
Stop. You have completed this procedure.
NTP-D148 Create a Manual Cross-Connect for a G-Series or
E-Series Card in Port-Mapped Mode
Note In this procedure, cross-connect refers to a circuit connection created within the same node between the
Ethernet card and an STM-N card connected to third-party equipment. You create cross-connects at the
source and destination nodes so an Ethernet circuit can be routed from source to destination across
third-party equipment.
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at an ONS 15454 SDH where you will create
the cross-connect. If you are already logged in, continue with Step 2.
Step 2 If you are provisioning an E-Series card, verify that the Ethernet card that will carry the circuit is
provisioned for port-mapped mode. See the “DLP-D246 Provision E-Series Ethernet Card Mode” task
on page 19-50.
Step 3 If you are provisioning a G-Series card, complete the “DLP-D222 Provision G-Series Ethernet Ports”
task on page 19-21.
Purpose This procedure manually creates a cross-connect between a G-Series
Ethernet card or an E-Series Ethernet card in Port-mapped mode and an
STM-N card connected to non-ONS equipment.
Tools/Equipment A G-Series or E-Series card must be installed at the circuit source node.
Prerequisite Procedures NTP-D127 Verify Network Turn-Up, page 6-5
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
