1-17
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 1 Install the Shelf and FMECs
NTP- D226 Install and Close the FMEC Cover
Step 2 To route twisted-pair cables, tie-wrap or lace the twisted-pair cables according to local site practice and
route the cables into the side cutouts on either side of the ONS 15454 SDH.
Step 3 Continue with the “NTP-D226 Install and Close the FMEC Cover” procedure on page 1-17 as needed.
Stop. You have completed this procedure.
NTP-D226 Install and Close the FMEC Cover
Step 1 Insert the cover carefully onto the left pin of the hinge (Figure 1-4).
Step 2 Move the cover to the right side towards the right pin of the hinge.
Step 3 Pull the right side of the hinge-locking spring (Figure 1-4). Push the cover onto the right pin until the
spring snaps into place.
Purpose This procedure installs and closes the rear cover.
Tools/Equipment #2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Prerequisite Procedures NTP-D219 Open and Remove the FMEC Cover, page 1-7
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
