Cisco ONS 15454 SDH - DLP- D134 Change the Optical Line Rate on the MRC-12 Card

18-28
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D134 Change the Optical Line Rate on the MRC-12 Card
Step 3 In the Pluggable Ports area, click Create. The Create Port dialog box appears.
Step 4 In the Create Port dialog box, complete the following:
• Port—Click the PPM number and port number from the drop-down list. The first number indicates
the PPM and the second number indicates the port number on the PPM. For example, the first PPM
displays as 1-1 and the second PPM displays as 2-1.
• Port Type—Click the type of port from the drop-down list. The port type list displays the supported
port rates on your PPM. See Table 18-4 for definitions of the supported rates on the MRC-12 card.
Step 5 Click OK.
Step 6 Repeat Steps 3 through 5 to configure the port rates as needed.
Step 7 Click OK. The row in the Pluggable Ports area turns light blue until the actual SFP is installed and then
the row turns white.
Step 8 Return to your originating procedure (NTP).
DLP-D134 Change the Optical Line Rate on the MRC-12 Card
Step 1 In node view, double-click the MRC-12 card where you want to provision PPM settings.
Step 2 Click the Provisioning > Pluggable Port Modules tabs.
Step 3 Click the port with the port rate you want to change in the Pluggable Ports area. The highlight changes
to dark blue.
Step 4 Click Edit. The Edit Port Rate dialog box appears.
Step 5 In the Change To field, use the drop-down list to select the new port rate and click OK.
Ta b l e 1 8 - 4 P P M P o r t Ty p e s
Card Port Type
MRC-12
• STM-1—155 Mbps
• STM-4—622 Mbps
• STM-16—2.48 Gbps
Purpose This task changes the optical line rate on a multirate PPM. Perform this
task if you want to change the port rate on a multirate SFP that is already
provisioned.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher