20-72
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D367 Provision a J2 Path Trace on Circuit Source and Destination Ports
Note OSI-only (LAP-D) is not available for MS-DCCs.
Step 8 If you checked OSI, complete the following steps. If you checked IP only, continue with Step 9.
a. Click Next.
b. Provision the following fields:
• Router—Choose the OSI router.
• ESH—Sets the ESH propagation frequency. End system NEs transmit ESHs to inform other ESs
and ISs about the NSAPs it serves. The default is 10 seconds. The range is 10 to 1000 seconds.
• ISH—Sets the ISH PDU propagation frequency. Intermediate system NEs send ISHs to other
ESs and ISs to inform them about the IS NETs it serves. The default is 10 seconds. The range
is 10 to 1000 seconds.
• IIH—Sets the IIH PDU propagation frequency. The IS-IS Hello PDUs establish and maintain
adjacencies between ISs. The default is 3 seconds. The range is 1 to 600 seconds.
• Metric—Sets the cost for sending packets on the LAN subnet. The IS-IS protocol uses the cost
to calculate the shortest routing path. The default metric cost for LAN subnets is 20. It normally
should not be changed.
Step 9 Click Finish.
Note Multiplex-Section DCC Termination Failure (MS-EOC) and LOS alarms appear until you create
all network DCC terminations and put the DCC termination STM-N ports in service.
Step 10 Return to your originating procedure (NTP).
DLP-D367 Provision a J2 Path Trace on Circuit Source and Destination Ports
Note This task assumes that you are setting up path trace on a bidirectional circuit and setting up transmit
strings at the circuit source and destination.
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Circuits tab.
Purpose This task creates a J2 path trace on VC12 circuit source ports and
destination ports.
Tools/Equipment ONS 15454 SDH cards capable of transmitting and/or receiving path trace
must be installed at the circuit source and destination ports. See
Table 20-30 on page 20-73 for a list of cards.
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
