15-27
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 15 Maintain the Node
NTP- D347 Export Network Element Defaults
A pencil icon appears next to any default value that will be changed as a result of importing the new
defaults file.
Step 6 Click Apply.
Step 7 If the imported file fails to pass all checks, the problem field shows the first encountered problem default
value that must be fixed. Change the problem default value and click Apply. Repeat until the imported
file passes all checks successfully.
Note Changes to most node defaults reprovision the node when you click Apply. Changes made to
card settings using the Defaults Editor do not change the settings for cards that are already
installed or slots that are preprovisioned for cards, but rather, change only cards that are installed
or preprovisioned thereafter. To change settings for installed cards or preprovisioned slots, see
Chapter 10, “Change Card Settings.”
Note Changing some NE defaults can cause CTC disconnection or a reboot of the node in order for
the default to take effect. Before you change a default, view the Side Effects column of the
Defaults editor (right-click a column header and select Show Column > Side Effects) and be
prepared for the occurrence of any side effects listed for that default.
Step 8 If you are modifying node-level defaults, a dialog box appears to confirm that you wan to apply defaults
for node level attributes and override current provisioning. Click Yes .
Step 9 If you are modifying the IIOP Listener Port setting, a dialog box appears warning you that the node will
reboot and asks if you want to continue. Click Ye s .
Stop. You have completed this procedure.
NTP-D347 Export Network Element Defaults
Note The defaults currently displayed are exported whether or not they have been applied to the current node.
Note The NE defaults can also be exported from the File > Export menu. These exported defaults are for
reference only and cannot be imported.
Purpose This procedure exports the NE defaults using the NE Defaults editor. The
exported defaults can be imported to other nodes.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
