Cisco ONS 15454 SDH - DLP- D91 MS-Spring Switch Test

17-84
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D91 MS-SPRing Switch Test
Note If the proxy server is configured as proxy-only or is disabled, you cannot set up a firewall tunnel.
Step 1 Click the Provisioning > Network > Firewall tabs.
Step 2 Click Create.
Step 3 In the Create Tunnel dialog box, complete the following:
• Source Address—Type the IP address of the source node (32 bit length) or source subnet (any other
length).
• Length—Choose the length of the source subnet mask.
• Destination Address—Type the IP address of the destination node (32 bit length) or destination
subnet (any other length).
• Length—Choose the length of the destination subnet mask.
Step 4 Click OK.
Step 5 Continue with your originating procedure (NTP).
DLP-D91 MS-SPRing Switch Test
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > MS-SPRing tabs.
Step 3 Click the row of the MS-SPRing you will switch, then click Edit.
Step 4 Initiate a Force Ring switch on the west port:
a. Right-click any MS-SPRing node west port and choose Set West Protection Operation. (To move
a graphic icon, click it, then press Ctrl while you drag and drop it to a new location.)
Note For two fiber MS-SPRings, the squares on the node icons represent the MS-SPRing working
and protect channels. You can right-click either channel. For four-fiber MS-SPRings, the
squares represent ports. Right-click either working or protect port.
b. In the Set West Protection Operation dialog box, choose FORCE RING from the drop-down list.
c. Click OK.
d. Click Yes i n the two Confirm MS-SPRing Operation dialog boxes that appear.
Purpose This task verifies that protection switching is working correctly in an
MS-SPRing.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed Required
Onsite/Remote Onsite
Security Level Provisioning or higher