Cisco ONS 15454 SDH - NTP- D310 Merge Circuits

7-11
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 7 Manage Circuits
NTP- D310 Merge Circuits
NTP-D310 Merge Circuits
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Click the Circuits tab.
Step 3 Click the circuit that you want to use as the master circuit for a merge.
Step 4 Click Edit.
Step 5 In the Edit Circuits window, click the Merge tab.
Step 6 Choose the circuits that you want to merge with the master circuit.
Step 7 Click Merge.
Step 8 In the confirmation dialog box, click Yes to continue.
Step 9 In the notification box, view the merge result. Click Ok.
Stop. You have completed this procedure.
NTP-D352 Manage VLANs
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 From the Tools menu, choose Manage VLANs. The All VLANS dialog box appears listing all of the
VLAN topologies in the network.
Step 3 Complete the following as necessary:
• To add a VLAN, complete the “DLP-D243 Create a VLAN” task on page 19-46.
Purpose This procedure merges two circuits that create a single, contiguous path but
are separate circuits because of different circuit IDs or conflicting
parameters. A merge combines a single master circuit with one or more
circuits.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure allows you to view, create, or delete VLANs.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher