Cisco ONS 15454 SDH - Figure 5-11 ONS 15454 SDH Open-Ended Sncps Fiber Connection Example; NTP- D258 Provision an Open-Ended SNCP

5-35
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 5 Turn Up a Network
NTP- D258 Provision an Open-Ended SNCP
Figure 5-11 ONS 15454 SDH Open-Ended SNCPs Fiber Connection Example
Step 2
Verify that the third-party cards or units to which the ONS 15454 SDH trunk cards are connected are the
same STM-N rate as the ONS 15454 SDH trunk cards. The third-party time slots must match the
ONS 15454 SDH card time slots to which they are connected. For example, if your trunk card is an
STM-16, the third-party vendor card or unit must have VC4s 1 to 8 available.
Step 3 Log into an ONS 15454 SDH in the SNCP you are turning up. See the “DLP-D60 Log into CTC” task
on page 17-49. If you are already logged in, continue with Step 4.
Step 4 Complete the “DLP-D363 Provision Regenerator-Section DCC Terminations” task on page 20-68 for
the ONS 15454 SDH cards/ports that are connected to another ONS 15454 SDH. (Alternatively, if
additional bandwidth is needed for CTC management, complete the “DLP-D364 Provision
Multiplex-Section DCC Terminations” task on page 20-71.) Do not create a DCC or MS-DCC
termination for the card/port that connects to the third-party equipment. For example, in Figure 5-11
DCC terminations are created at the following cards/ports:
• Nodes 1 and 6: Slot 5 and Slot 12
• Node 2 and 5: Slot 12
96488
Node 2
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 1
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 6
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 4
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 3
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 5
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Third Party
Network