EasyManua.ls Logo

Cisco ONS 15454 SDH - DLP- D299 Initiate an MS-Spring Span Lockout

Cisco ONS 15454 SDH
860 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19-84
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 19 DLPs D200 to D299
DLP- D299 Initiate an MS-SPRing Span Lockout
DLP-D299 Initiate an MS-SPRing Span Lockout
Caution Traffic is not protected during a span lockout.
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > MS-SPRing tabs.
Step 3 Choose the MS-SPRing and click Edit.
Tip To move an icon to a new location, for example, to see MS-SPRing channel (port) information more
clearly, click an icon on the Edit MS-SPRing network graphic and while pressing Ctrl, drag the icon to
a new location.
Step 4 To lock out a west span:
a. Right-click any MS-SPRing node west channel (port) and choose Set West Protection Operation.
Figure 19-4 shows an example.
Note For two-fiber MS-SPRings, the squares on the node icons represent the MS-SPRing working
and protect channels. You can right-click either channel. For four-fiber MS-SPRings, the
squares represent ports. Right-click either working port.
b. In the Set West Protection Operation dialog box, choose LOCKOUT SPAN from the drop-down
list. Click OK.
c. In the Confirm MS-SPRing Operation dialog box, click Yes . An “L” indicating the lockout appears
on the selected channel (port) where you invoked the protection switch.
Performing a lockout switch generates LKOUTPR-S and FE-LOCKOUTOFPR-SPAN conditions.
Step 5 To lock out an east span:
a. Right-click the node’s east channel (port) and choose Set East Protection Operation.
b. In the Set East Protection Operation dialog box, choose LOCKOUT SPAN from the drop-down list.
Click OK.
c. In the Confirm MS-SPRing Operation dialog box, click Yes . An “L” indicating the lockout appears
on the selected channel (port) where you invoked the protection switch.
Performing a lockout switch generates LKOUTPR-S and FE-LOCKOUTOFPR-SPAN conditions.
Purpose This task performs an MS-SPRing span lockout, which prevents traffic
from switching to the locked-out span.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher

Table of Contents

Other manuals for Cisco ONS 15454 SDH

Related product manuals