2-20
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 2 Install Cards and Fiber-Optic Cable
NTP- D227 Remove and Replace a Card
Figure 2-3 Routing Fiber-Optic Cables on the Optical-Card Faceplate
Step 5 Route the fiber cables into the cable-management tray (Figure 2-3).
Step 6 Route the fiber cables out either side of the cable-management tray through the cutouts on each side of
the shelf assembly. Use the reversible fiber guides to route cables out the desired side.
Step 7 Close the fold-down front door when all fiber cables in the front compartment are properly routed.
Stop. You have completed this procedure.
NTP-D227 Remove and Replace a Card
Step 1 If you are not logged into CTC and you need to remove a card, remove the card as described in Step 3.
When you log into CTC, troubleshoot the mismatched equipment alarm (MEA) using the
Cisco ONS 15454 SDH Troubleshooting Guide.
61238
Tx
Rx
FAI L
ACT
SF
Faceplate connector
Cable connector
Cutout
Fold down faceplate
Retaining clip
Slot on cable management tray
Purpose This procedure removes and replaces cards in the ONS 15454 SDH shelf.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
