18-72
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D185 Manage the TARP Data Cache
DLP-D185 Manage the TARP Data Cache
Step 1 In node view, click the Maintenance > OSI > TDC tabs.
Step 2 View the following TARP data cache information:
• TID—The target identifier of the originating NE. For ONS 15454 SDH nodes, the TID is the name
entered in the Node Name/TID field on the Provisioning > General tab.
• NSAP/NET—The Network Service Access Point or Network Element Title of the originating NE.
• Type—Indicates how the TDC entry was created:
–
Dynamic—The entry was created through the TARP propagation process.
–
Static—The entry was manually created and is a static entry.
Step 3 If you want to query the network for an NSAP that matches a TID, complete the following steps.
Otherwise, continue with Step 4.
Note The TID to NSAP function is not available if the TARP data cache is not enabled on the
Provisioning > OSI > TARP tab.
a. Click the TID to NSAP button.
b. In the TID to NSAP dialog box, enter the TID you want to map to an NSAP.
c. Click OK, then click OK in the information message box.
d. On the TDC tab, click Refresh.
If TARP finds the TID in its TDC, it returns the matching NSAP. If not, TARP sends PDUs across
the network. Replies will return to the TDC later, and a “check TDC later” message appears.
Step 4 If you want to delete all the dynamically generated TDC entries, click the Flush Dynamic Entries
button. If not, continue with Step 5.
Step 5 Return to your originating procedure (NTP).
Purpose This task allows you to view and manage the TDC. The TDC facilitates
TARP processing by storing a list of TI-to-NSAP mappings.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
