5-8
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 5 Turn Up a Network
NTP- D340 Linear ADM Network Acceptance Test
Note Terminating nodes (Nodes 1 and 3 in Figure 5-1) will have one DCC termination, and
intermediate nodes (Node 2 in Figure 5-1) will have two DCC terminations (Slots 5 and 12 in
the example).
Step 6 As needed, complete the “DLP-D81 Provision a Proxy Tunnel” task on page 17-73.
Step 7 As needed, complete the “DLP-D90 Provision a Firewall Tunnel” task on page 17-83.
Step 8 As needed, complete the “DLP-D40 Create a Provisionable Patchcord” task on page 17-31.
Step 9 Verify that timing has been set up at each linear node. If not, complete the “NTP-D28 Set Up Timing”
procedure on page 4-9. If a node is using line timing, use its working STM-N card as the timing source.
Step 10 Complete the “NTP-D340 Linear ADM Network Acceptance Test” procedure on page 5-8.
Stop. You have completed this procedure.
NTP-D340 Linear ADM Network Acceptance Test
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 on a node in the linear ADM network you
are testing. If you are already logged in, continue with Step 2.
Step 2 From the View menu, choose Go to Network View.
Step 3 Click the Alarms tab.
a. Verify that the alarm filter is not on. See the “DLP-D227 Disable Alarm Filtering” task on
page 19-25 as necessary.
b. Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if necessary.
c. Complete the “DLP-D147 Export CTC Data” task on page 18-38 to export alarm information.
Step 4 Click the Conditions tab.
a. Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if
necessary.
b. Complete the “DLP-D147 Export CTC Data” task on page 18-38 to export condition information.
Step 5 On the network map, double-click the linear ADM node you are testing to open it in node view.
Step 6 Create a test circuit from that node to an adjacent linear ADM node.
Purpose This procedure tests a linear ADM network.
Tools/Equipment Test set and cables appropriate to the test circuit you will create.
Prerequisite Procedures NTP-D38 Provision a Linear ADM Network, page 5-7
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
