6-66
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D62 Test High-Order Circuits
c. Port, VC4—Choose the port and/or VC4 from the Port and VC4 drop-down lists. The choice in these
drop-down lists depends on the card selected in Step b. See Table 6-2 on page 6-3 for a list of
options.
d. The routing preferences for the new drop match those of the original circuit. However, you can
modify the following:
• If the original circuit was routed on a protected SNCP path, you can change the nodal diversity
options: Nodal Diversity Required, Nodal Diversity Desired, or Link Diversity Only. See
Step 13 for descriptions.
• If the original circuit was not routed on a protected path, the Protection Channel Access option
is available. See Step 12 for a description of the Protection Channel Access option.
e. Click OK. The new drop appears in the Drops list.
Step 23 If you need to create additional drops on the circuit, repeat Steps 21 and 22.
Step 24 Click Close. The Circuits window appears.
Step 25 Verify that the new drops appear in the Destination column for the circuit that you edited. If they do not
appear, repeat Steps 21 through 24, making sure that all options are provisioned correctly.
Step 26 Complete the “NTP-D62 Test High-Order Circuits” procedure on page 6-66.
Stop. You have completed this procedure.
NTP-D62 Test High-Order Circuits
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at an ONS 15454 SDH on the network
where you will test the high-order circuits. If you are already logged in, continue with Step 2.
Step 2 From the View menu, choose Go to Network View.
Step 3 Click the Circuits tab.
Purpose This procedure tests a high-order circuit.
Tools/Equipment Test set capable of optical speeds, appropriate fibers, and attenuators
Prerequisite Procedures This procedure assumes that you completed facility loopback tests to test
the fibers and cables from the source and destination ONS 15454 SDHs to
the fiber distribution panel or the DSX and one of following circuit
procedures:
NTP-D323 Create an Automatically Routed High-Order Circuit, page 6-55
NTP-D324 Create a Manually Routed High-Order Circuit, page 6-60
NTP-D190 Create a Unidirectional High-Order Circuit with Multiple
Drops, page 6-63
NTP-D284 Create a Manually Routed VCAT Circuit, page 6-101
NTP-D325 Create an STM Test Circuit around the Ring, page 6-103
Required/As Needed Required
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
