Cisco ONS 15454 SDH - DLP- D194 Clear an MS-Spring Force Ring Switch

18-82
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D194 Clear an MS-SPRing Force Ring Switch
DLP-D194 Clear an MS-SPRing Force Ring Switch
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > MS-SPRing tabs.
Step 3 Click Edit.
Step 4 To clear a Force switch on the west line:
a. Right-click the MS-SPRing west port where you want to clear the protection switch and choose
Set West Protection Operation. Ports with a force switch applied are marked with an F.
b. In the Set West Protection Operation dialog box, choose CLEAR from the drop-down list. Click
OK.
c. In the Confirm MS-SPRing Operation dialog box, click Yes .
Step 5 To clear a Force switch on the east line:
a. Right-click the MS-SPRing east port where you want to clear the protection switch and choose
Set East Protection Operation. Ports with a Force switch applied are marked with an F.
b. In the Set East Protection Operation dialog box, choose CLEAR from the drop-down list. Click OK.
c. In the Confirm MS-SPRing Operation dialog box, click Yes .
On the MS-SPRing network graphic, a green and a purple span line connects each node. This is the
normal display for MS-SPRings when protection operations are not invoked.
Step 6 From the File menu, choose Close.
Step 7 Return to your originating procedure (NTP).
DLP-D195 Verify Timing in a Reduced Ring
Step 1 In node view, click the Provisioning > Timing > General tabs.
Purpose This task removes a Force switch from an MS-SPRing port.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
Purpose This task verifies timing in the ring where you removed a node.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite/remote
Security Level Provisioning or higher