Cisco ONS 15454 SDH - DLP-D151 Set up SNMP for a GNE

18-43
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D151 Set Up SNMP for a GNE
• Revertive—Check this box if you want traffic to revert to the working card after failure conditions
stay corrected for the amount of time chosen from the Reversion Time drop-down list. Uncheck if
you do not want traffic to revert.
• Reversion time—If the Revertive check box is selected, choose the reversion time from the
Reversion time drop-down list. The range is 0.5 to 12.0 minutes. The default is 5.0 minutes. This is
the amount of time that will elapse before the traffic reverts to the working card. Traffic can revert
when conditions causing the switch are cleared.
Step 4 Click Apply. Confirm that the changes appear; if not, repeat the task.
Note To convert 1:1 protection groups, see the “NTP-D91 Upgrade E1-N-14 and DS3 i-N-12 Protect
Cards from 1:1 Protection to 1:N Protection” procedure on page 10-4.
Step 5 Return to your originating procedure (NTP).
DLP-D151 Set Up SNMP for a GNE
Step 1 In node view, click the Provisioning > SNMP tabs.
Step 2 In the Trap Destinations area, click Create.
Step 3 In the Create SNMP Trap Destination dialog box, complete the following fields:
• Destination IP Address—Enter the IP address of your network management system (NMS).
• Community—Enter the SNMP community name. (For more information about SNMP, refer to the
“SNMP” chapter in the Cisco ONS 15454 SDH Reference Manual.)
Note The community name is a form of authentication and access control. The community name
assigned to the ONS 15454 SDH is case-sensitive and must match the community name of
the NMS.
• UDP Port—The default User Datagram Protocol (UDP) port for SNMP traps is 162.
• Trap Version—Choose either SNMPv1 or SNMPv2. Refer to your NMS documentation to determine
whether to use SNMPv1 or SNMPv2.
Step 4 Click OK. The node IP address of the node where you provisioned the new trap destination appears in
the Trap Destinations area.
Purpose This procedure provisions Simple Network Management Protocol (SNMP)
parameters so that you can use SNMP network management software with
the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher